
The physical and mechanical properties of the product represent an unprecedented development for conveyor belt cover properties for the toughest applications.
Characteristics such as the abrasion level, tensile strength and elongation at break are increased to levels beyond those that can be achieved with any type of rubber.
These properties allow thinner belts to be used than a standard rubber equivalent whilst improving belt lifetime and offering considerable energy potential.
The belt carcass is usually a standard construction. The SRC-35 cavers can be applied to just one cover or to both top and bottom covers.
Belt dimensions are calculated and matched to the requirements of the service load, demands of the installation and client request.
Dimensions | Value |
Top cover (mm) | Between 2 and 10 |
Bottom cover (mm) | Between 2 and 10 |
Tensile strength | Client request |
Maximum width (mm) | 1800 |
Maximum length (m) | Client request |
Thickness (mm) | Client request |
Weight (Kg/m2) | To be advised depending on the belt spec |
Mechanical properties | Unit | Value |
Tensile strength DIN53504 | MPA | min 51 |
Elongation at break DIN53504 | % | 425 |
Hardness ISO868 | Sh.A | 85 |
Density DIN53505 | gr/cm3 | 1.2 |
Abrasion DIN53516 | mm3 | 30 |
Compression SET 72h; 23Cº ISO 815, | % | 25 |
Resilience impact ISO 4662 | % | 42 |
Tear propagation resistance ISO 31-1 | Kn/m | 70 |
Temperature range | ºC | -30 – +70 |
Other characteristics:
Oil and fat resistant.
FDA approved for the food industry.